Click here for the Introduction Video
The G Scale Flasher kit (12VDC) allows you put animation your layout in seconds. We recommend using the rubber mounting blocks even if you plan to install into the ground.
SOLAR BATTERY SYSTEM AVAILABLE – ORDER SEPARATELY and CHOSE NO POWER SUPPLY HERE.
The Non battery setup has a slimmer Electrical Box as shown below. The 12VDC system can be run on the power from the Battery Version. Up to 4 G- Controllers can be run on the battery but of course battery life will be reduced. We suggest two.
We pioneered the use of a non infrared style sensor which we call a Precision Sensor. The sensor has a 1mm precision on range detection and will work in direct sunlight or pitch dark. You can manually or automatically (Auto Ranging) set the detect distance.
The Sensor has a variable Timeout adjustment. That means you can delay the start of the light aspect changing from zero to up to 60 seconds after the train has cleared the sensor.
The G-Controller allows you to adjust the speed by which the Flasher flash and you can adjust the brightness of the lights.
Additional stand alone sensors can be interconnected to yield a longer block detect area.
Contact us if you would like connectors. This will significantly delay your order.
- Choice of Single or Double Flasher
- G Signal Controller with built in MAX Sensor ( Outdoor/Indoor Use)
- Electrical Box
- Mounting Magnets and installation Template
A. (4″ x 4″) Heavy Weight Rubber Mounting Block; holes drilled with Resin Feet ($10 x 2)
B. (4″ x 6″) Heavy Weight Rubber Mounting Block; holes drilled with Resin Feet ($20)
THE NEW FLASHER HEAD IS THE SAME AS THE NEW MOTORIZED GATE CROSSING SHOWN BELOW:
4″ x 4″ x 1″ Rubber Mounting Block ($10 each)
12VDC Power Supply with Barrel Plug to Wired Connector
- Automatic overload cut-off
- Over Voltage cut-off
- Automatic thermal cut-off
- Short circuit protection